Mechanical Engineering projects, Dissertation topics, Thesis, Mechanical project report ideas, Mechanical engineering project list, Mechanical projects for final year students, Mech engg project topics, Mini projects, Major project mechanical engineering
This work presents a design of drying small food particles like tea, tobacco with a reduced height of about fifty percent compared to the convectional straight type. The geometry is designed such that, the particle leave the dryer at an average constant
A simplified FE-model of the subcomponent of the Charge air cooler – core is modelled using homogenisation technique. Modal testing was performed on the physical model of the same. On comparing the resonance frequencies of the test data (reference result) with FE-model
Main task of thesis is to study the effect of Mode dependent Rayleigh damping on System response. Damping ratio for the structure is not constant for all modes and it varies mode wise. In present task different damping models are defined and
Footbriges are often prone to vibrations induced by pedestrian loading. They are long and slender and their weight is moderate. One of the classical and famous examples is the transverse vibrations encountered on the millennium bridge in London. Horizontal vibration problems have
The present thesis work studies the parametrically excited vibrations on bridge stay cables when the natural frequency of the bridge tower is half of the resonance frequency of the cable. This condition is found at the longest stay cables of the resund
Reverse engineering, as the name implies is an engineering process going in reverse. The process has in resent times emerged from the shadows of engineering science to become common in many organisations today. To study engineering can be difficult, especially transforming theoretical
The ability of solid oxide fuel cells (SOFC’s) to operate with carbonaceous fuels depends on their ability to oxidize CO through direct electrochemical oxidation and/or water-gas-shift reactions with subsequent H2 electrochemical oxidation… Contents 1. Introduction 1.1. Introduction to Solid Oxide Fuel Cells
It is probable that all practical engineering structures are nonlinear to some extent. In this thesis work a two degrees of freedom nonlinear system and experimental structure with zero memory were simulated, modeled and analyzed to understand their behavior for different conditions.
In classical mechanical engineering the predominant group of system analysis and identification tools relies on Linear Systems, where research have been carried out for over half a century. Usage of Linear Systems is most widely spread, often due to its simple mathematics
This report takes an insight look into the process zone of a thin laminated composite. Mostly work was focused on microscopic observation and thickness calculations around the process zone of laminates. The laminates used in the work are Aluminium and Polyethylene. Investigations